Seat position memory (front passenger’s seat)

Your preferred front passenger seat position can be memorized and recalled with the touch of a button.

Two different seat positions can be entered into memory.

 

Entering a position to memory

 

Turn the “ENGINE START STOP” switch to IGNITION ON mode.

Adjust the front passenger seat to the desired position.

Push the “SET” button, then

 

Push the “SET” button, then within 3 seconds push button 1 or 2 until the signal beeps.

If the selected button has already been preset, the previously recorded position will be overwritten.

Recalling the memorized position

 

Check that the shift lever is set in P.

Push button 1 or 2 to recall the

 

Push button 1 or 2 to recall the memorized position.

Retained accessory power

 

Memorized position can be activated up to 180 seconds after the front passenger
door is opened, even after turning the “ENGINE START STOP” switch OFF.

To cancel seat position recall

 

Perform any of the following operations.

- Push the “SET” button.

- Push button 1 or 2.

- Adjust the seat position using the switches.

If the battery is disconnected

 

The memorized positions are erased when the battery is disconnected.

CAUTION:
Seat adjustment caution
Take care during seat adjustment that the seat does not strike the rear passenger.

 

    See also:

    Immobilizer system
    The vehicle's keys have built-in transponder chips that prevent the hybrid system from starting if the key has not been previously registered in the vehicle's on-board computer. Never leave the key ...

    Bluetooth® audio system
    The Bluetooth® audio system enables you to enjoy music played on a portable digital audio player (portable player) from the vehicle speakers via wireless communication. This audio system supports ...

    Wheels
    If a wheel is bent, cracked or heavily corroded, it should be replaced. Otherwise, the tire may separate from the wheel or cause a loss of handling control. Wheel selection When replacing wheels, ...